SURE petcare SureFlap Mikrochip cat flap Guide D'utilisation page 11

Now remove all of the material in the centre using the most
suitable tools for the material you're cutting. We do not
recommend that you cut through to the outside in one go.
7
Cut away material on the inside of the house first and then
move outside to cut the remainder of the hole. Try to keep the
hole within the outlined area otherwise it will be too big.
We recommend using one of the tunnel extenders to make
8 sure you have a clear path through the wall. Once this is
the case, clear away any dust and debris.
10mm
To extend the cat flap's tunnel through to the outside
wall, you need to use the tunnel extender accessories
to make up this length. To calculate how many
9
extenders you will need, please go to page 17. It is
important to remember that the end has to stick out by
at least 10mm (3/ 8 ") for the external frame to rest on.
50mm
Stack the tunnel extenders together and then attach them
to the end of the cat flap's tunnel, using all weather tape
between each join to hold them together. Do not glue the
tunnel extenders or cat flap together. From the inside of the
10
house, feed the extended tunnel into the hole in the wall until
the cat flap is flush against the wall. If no adjustment to the
hole shape or size is needed then you are at the point where
you can attach the cat flap to the inside of the house.
The cat flap can be secured directly to your inside wall.
To access the screw holes needed, you have to unscrew
the front frame from the tunnel. To do this, first remove
11
the battery cover and screw covers, then unscrew the 4
screws and lastly pull the tunnel and front frame apart.
Now locate the 4 screw holes, they are the
larger holes in the corners of the cat flap.
12
Mark the hole positions using a sharp pencil.
19
Remove the cat flap from the wall and place it away from
the work area. Drill the four holes using the appropriate drill
bits to suit the construction of your wall, being careful not to
13
break through the edge of the main hole. Once drilled, put
the wall plugs into each of the holes.
Replace the cat flap, with its extended tunnel, back into the
14 hole. Then, using the appropriate screws for your wall plugs,
screw the cat flap to the wall - see the diagram.
Screw the front frame back onto the tunnel. It is important
that these parts are fitted together correctly, please ensure
that the gap between the parts is no bigger than a credit
15
card thickness. Once screwed together put battery cover and
internal screw covers back onto your cat flap.
Now you can move to the outside of the house. The extended
16 tunnel should be poking out of the hole. Place the external
frame over the tunnel.
Lastly, use an All-Weather sealant to seal the gap
between the tunnel and the external frame. We
17
also recommend putting some sealant around
the join between the external frame and the wall.
18 Now, insert the two screw caps into the external frame.
EN
20