Operating a specific unit with the remote
commander
When multiple pieces of Sony equipment are connected via the
CTRL S jack, you can operate a specific piece of equipment by
assigning the index number preset for each piece of equipment
on the converter, and then on the remote commander.
For presetting the index number on each piece of equipment,
refer to the Instruction Manual of the equipment.
The following explanation is an example of use of the RM-854
remote commander.
Assigning the index number on the converter
1
Press the MENU button once.
The MENU 1 screen appears.
MENU
2
Press the CENT ◊/√ button to move the cursor (z) to
INDEX NO. and press the ENTER button.
The INDEX NO. screen appears.
ENTER
CENT
3
Press the CENT ◊/√ button repeatedly to select the
index number (1 to 255) of the equipment you want to
control, and press the ENTER button.
4
To quit the menu, press the MENU button three times.
ID:3
Remote signal
ID:2
CTRL S OUT
SIGNAL FORMAT
IN
NTSC
PAL
31.5k
37k
48k
64k OTHERS
ON/OFF
OUT
NTSC
PAL
31.5k
37k
48k
64k
GEN-LOCK
Remote
commander
MENU 1
zMEM LOAD
MEM SAVE
GEOM RESET
COLOR RESET
ALL RESET
INDEX NO.
LANGUAGE
USE:
ENTER NEXT:MENU
INDEX NO.
INDEX NO.:001
USE:
ENTER CANCEL:MENU
CTRL S IN
CTRL S OUT
CTRL S IN
OPEN
SCAN CONVERTER DSC-1024
INPUT SELECT
1
2
3
Operating the equipment with the RM-854 remote
commander
1
Press the ID MODE ON button on the remote
commander.
The index numbers appear on all the pieces of equipment
including the converter.
ID MODE
ON
OFF
SET
2
Input the index number of the equipment you want to
operate using 0–9 buttons of the remote commander.
The input number appears right next to each equipment
own index number.
1
2
3
4
5
6
7
8
9
10
0
3
Press the ID MODE SET button.
The character on the selected equipment changes to cyan
while others change to red.
ID MODE
ON
OFF
SET
Now you can operate only a specified equipment (All
operations available in ID mode except POWER ON/OFF).
...
INDEX NO. : 001
INDEX NO. : 001 001
41