Phonocar PH908 Notice De Montage Et D'emploi page 7

Impostazioni • Settings
EN
SUMMING SCREEN
In this screen you can choose inputs or sum of inputs
with regard to the outputs by clicking
first on "OUTPUT" and then on "INPUT" (sum of inputs)
assigning then input "IN" to output "OUT".
When the device is turned on, the inputs are already as-
signed to the corresponding outputs.
CALL OF THE INTERNAL PRESET TO THE DSP:
Each time you connect your device to the DSP, you will
need to reload the preset inside the DSP.
This is done by clicking on the icon at the top right and
waiting for the upload.
Once the upload has taken place, the application will
display the last saved setting on the DSP.
NB. The first time you turn it on, this operation is neces-
sary to start working with the DSP.
EXAMPLES
1
- SCREEN
One channel out, you give one channel in:
Output channel 1 "CH1 OUT" is connected to input
channel 1 "CH1 IN".
Output channel 2 "CH2 OUT" is connected to input
channel 2 "CH2 IN".
The remaining IN&OUT channels are not assigned.
2
- SCREEN
One output channel is assigned two input channels.
Output channel 1 "CH1 OUT" is connected to input
channel 1&2 "CH1 IN" and "CH2 IN".
The remaining IN &OUT channels are not assigned.
3
- SCREEN
Two-channel output is assigned the same input chan-
nel.
Output channel 1 "CH1 OUT" is connected to input
channel 1 "CH1 IN".
Output channel 2 "CH2 OUT" is connected to input
channel 1 "CH1 IN".
The remaining IN&OUT channels are not assigned.
With these combinations, you can decide the "routing"
of your signal by mixing or adding up
the channels according to the installation or the techni-
cal requirements of the system.
ATTENTION: The first 4 input channels are LOW LE-
VEL. The second 4 channels are HIGH LEVEL.
Not using the first 4 input channels with HIGH LEVEL
signal could irreparably damage the
boxes and the overall system of the car.
7
IT-EN