Roland Edirol UM-1X Mode D'emploi page 23

6
The display will indicate "Important Information."
Read the contents and click [Continue].
7
The display will indicate "Select a Destination."
Click the drive in which the operating system is
installed to select it, and then click [Continue].
8
The display will indicate "Easy Install."
Click Install or Upgrade.
9
The display will indicate "Installing this software
requires you to restart your computer when the
installation is done. Are you sure you want to
install the software now?"
Click [Continue Installation].
10
The display will indicate "The software was
successfully installed."
Click [Restart] to restart your computer.
This completes installation of the UM-1X driver.
Cautions when using the UM-1X
Before you use your sequencer software, please note the following points.
* Connect the UM-1X to your computer via a USB cable before you start up your
sequencer or other software.
* Do not disconnect the UM-1X's USB cable while your sequencer or other software is
running.
* Exit your sequencer software before you unplug the UM-1X's USB cable.
* Leave the Sleep function of your Macintosh turned off.
* The UM-1X will not work in the Classic environment of Mac OS X. Use the UM-1X
when the Classic environment is not running.
Getting Connected and Installing Drivers (Macintosh)
Select the Startup Disk as the
drive.
23