Connect The Probe - Metrix DOX3104 Guide De Démarrage

1.6. Using Security Lock
Using Security Lock
If needed, you can use the security lock to lock the
instrument in a fixed location. The method: align the
clock with the clock hole and plug it into the lock hole
vertically, turn the key clockwise to lock the instrument
and then pull the key out.
1.6. Power-on Inspection
When the scope is energized, turn on the power switch
at the lower left corner on the front panel. During the
start-up process, the instrument performs a series of
self-test items and you can hear the sound of relay
switching. After the self-test completed, the user
interface displays immediately.
English

1.7. Connect the Probe

CHAUVIN ARNOUX provides passive probe for the
DOX3x04 oscilloscopes. Please refer to corresponding
Probe User Manual for detailed technical information.
3. Connect the BNC terminal of the probe to one of
the channel BNC connector of the front panel.
4. Connect the probe tip to the circuit point to test
and the ground alligator clip of the probe to the
ground terminal of the circuit.
1.8. Function Inspection
1. Press button to restore the oscilloscope to its
default setup.
2.
3. Use the probe to connect the CH1 Input Terminal and
the Compensation Signal Output Terminal on the front
panel.
4. Press
5. Observe the waveform on the screen. In normal
condition, the display should be a square waveform as
shown in the picture hereafter:
23
Connect the ground alligator clip of the
probe to the Ground Terminal on the
front panel.