Publicité
Les langues disponibles
Les langues disponibles
System status
To view the system status of the oscilloscope:
Startup times,
Software version,
FPGA version,
Hardware version,
Product type,
Serial no.,
Scope ID.
Do Self Calibration
The self-calibration program can quickly make the
oscilloscope reach the best working state to get the most
precise measurement values. You can perform self-
calibration at any time especially when the change of the
environment temperature is up to or more than 5 ℃. Make
sure that the oscilloscope has been warmed up or operated
for more than 30 minutes before the self-calibration.
Press the button to enable HELP function and
then press down any menu to display
corresponding help information. To display the
submenus help information of the current
menu, firstly you should open the current menu, and then
press down the "HELP" button, the last step is to select any
submenu you want.
Press the button to enable print function. If the
instrument is connected to a printer which is
usable, press it to perform print function.
English
Press the button to enter the measurement
setting menu. You could set measurement
setting, statistic function and all measure. In
measurement setting, you could select as many as five
parameters and display them simultaneously on the screen.
In statistic function, the current value, Mean value, Min
value, Max value, Std-Dev and Counts are displayed on the
screen. In all measure, you could display all Voltage/Time/
Delay parameters by pressing the corresponding softkey.
Press the button to enter the sample setting
menu to set the acquisition mode (Normal/Peak
Detect/Average/High Res), dot inserting mode
and max. memory depth
(7K/14K/70K/140K/700K/1.4M/7M/14M) but
1CH/14M selected 28 Mpts.
Press the button to enter the file save and recall
function menu. The storable file type includes
Setups, Waveforms, Picture and CSV:
On instrument recall files:
-
Setup.SET
-
Waveform.DAV
On PC recall files:
-
Excel.CSV
-
Picture.BMP
31
Publicité
