Metrix DOX3104 Guide De Démarrage page 28

1.12. Front Panel Function Brief
Horizontal Control
 Press the
button to open waveform display
mode menu. The selectable modes include: X-Y/Y-
T/ROLL.
 Press the
button to open delay sweep function.
Press again to turn it off.
Horizontal position
Modify the trigger position. The waveform will
move left or right when you revolve the knob.
Meanwhile, the Delay value will also increase or
decrease as the waveform moves. Press down the knob
to return the waveform to horizontal centre of the screen.
Horizontal Time Base
Modify the horizontal time base. Turn it
clockwise or counter-clockwise to reduce or
increase the time base. The waveform will
display expanded or compressed and the time base
message at the upper left of the screen will change as
the time base changes.
English
Trigger Control
Press the
trigger types are provided: Edge, Slope, Pulse, Video,
Window, Interval, DropOut, Runt, Pattern and Serial Bus
I2C/SPI/UART/RS232/CAN/LIN.
 Press the
 Press the
 Press the
 Modify the
counter-clockwise to make the level move up or down.
In the meanwhile, the level value displayed at the upper
right of the screen will increase or decrease. Press it down
to quickly reset the trigger level to the vertical centre of
corresponding waveforms.
27
button to open trigger menu. Various
button to set to Normal trigger mode.
button to set to Single trigger mode.
button to set to Auto trigger mode.
trigger level knob. Turn it clockwise or