Establishing And Testing The Wireless Connection (Wireless Repeater Frp) - BRÖTJE RGTF Instructions De Montage

5.4 Establishing and testing the
wireless connection (wireless
repeater FRP)
Fig. 8: Key and LED on wireless repeater FRP
136 230 06.11
Establishing the wireless connection
Note: Carry out the wireless connection with loose components near the FE receiv-
er to ensure that all components are within range.
In order to establish the wireless connection between wireless receiver FE and
wireless repeater FRP, the following conditions must be met:
- the FE receiver must be correctly connected at the boiler
- the wireless repeater FRP must be correctly connected at the mains adaptor
The wireless connection to the wireless repeater FRP is established as follows:
1. Hold down the key on the FE receiver until the LEDs
key
C0006268
2. Keep the key on the wireless repeater FRP pressed for at least 8 seconds until
the LED flashes quickly (Fig. 8)
For more information on changing parameters, see the Boiler installation instruc-
tions.
For information on the wireless repeater FRP, see the Wireless repeater FRP installa-
tion instructions.
Note: Connection has been made when the LED
receiver and then illuminates permanently.
Testing the wireless connection
The wireless connection to the wireless repeater FRP is tested as follows:
1. Hold down the key on the FE receiver until the LEDs
2. Press the key on the wireless repeater FRP for approx. 3-8 seconds until the LED
flashes slowly
Note: If the connection is working, the LED on the wireless receiver FE illuminates
briefly every 10 s
3. Terminate the connection test by pressing the key on the wireless receiver FE
and the wireless transmitter FSA
For information on the wireless repeater FRP, see the Wireless transmitter FA instal-
lation instructions.
Wireless receiver FE
Commissioning
and illuminate
LED
flashes a few times on the FE
and illuminate
GB
29