Establishing And Testing The Wireless Connection - BRÖTJE RGTF Instructions De Montage

5.2 Establishing and testing the
wireless connection (room
controller RGTF/RGTKF)
Tab. 2: Wireless parameter (selection)
Prog. no. Setting level
Wireless
120
121
138
136 230 06.11
Establishing the wireless connection
Note: Carry out the wireless connection with loose components near the FE receiv-
er to ensure that all components are within range.
In order to set up the wireless connection between the FE receiver and RGTF/
RGTKF room controller, the following conditions must be met:
- the FE receiver must be correctly connected at the boiler
- the batteries of the RGTF/RGTKF room controller must be inserted correctly
The wireless connection to the RGTF/RGTKF is established as follows:
1. Hold down the key on the FE receiver until the LEDs
2. At the RGTF/RGTKF room controller, call up the menu option Wireless at the
setting level Commissioning (C)
3. Select function Binding (prog. no. 120)
4. Select option "Yes" to start building the connection
For more information on changing parameters, see the Boiler installation instruc-
tions.
For information on the RGTF/RGTKF room controller, see Installation instructions,
RGT/RGTK B and RGTF/RGTKF B room controllers.
Note: The status of the connection process will be shown in the display of the
RGTF/RGTKF room controller. Connection has been made when the LED
few times on the FE receiver and then illuminates permanently.
Function
Binding
C
Yes | No
Test mode
C
Yes | No
Delete all devices
C
Yes | No
Testing the wireless connection
The wireless connection to the RGTF/RGTKF is tested as follows:
1. Hold down the key on the FE receiver until the LEDs
2. At the RGTF/RGTKF room controller, call up the menu option Wireless at the
setting level Commissioning (C)
3. Select "Test mode" (prog. no. 121)
4. Select option "Yes" to start the connection test
Wireless receiver FE
Commissioning
and illuminate
flashes a
Standard value
No
No
No
and illuminate
GB
25