Threading The Bobbin Thread - Bernette MOSCOW 2 Mode D'emploi

E55-E82e_EN_ES_FR_PT_310309:07_55-90e_EN_ES_FR_PT.qxd
Moscow 5 / 7
31.3.2009 14:31 Seite 38
GB EN
Caution:
· Turn power switch to "O" before
threading or unthreading the machine.
· The thread take-up lever must be in the
highest position when threading.
· A wrong threading in can cause
damages to the machine!
To open the bobbin cover, slide it against
you.
1. Inserting the bobbin in the bobbin holder
with the thread running counter
clockwise direction.
2. Pull the thread along the arrow marking
through the slit under the finger (A) as
far as the pulley (B).
3. To make sure that the thread is pulled
into the tension spring of the bobbin
holder, press a finger slightly onto the
bobbin while pulling. As a check you
must feel a resistance in the thread feed.
4. Pull the thread at the arrow markings
into the stitch plate thread guide from
(B) to (C).
To cut off excess thread pull thread back
over the cutting off blade at point (C).
To close the bobbin cover, push it to the
back.
Threading the bobbin
thread