Electrical System; System With Integrated Bidet - Thetford Marine TECMA Design Line Installation Et Mode D'emploi

Electrical system

3.8.2.2
Diagram in section A.3.3/4. Every control unit is wired by connecting
Black/brown
Black/Blue
Black/Grey
Black/Red
The « BEFORE USE » button starts the pump, whilst the « AFTER USE » pump starts a
program, which activates the pump before starting the toilet motor.

System with integrated Bidet

The integrated bidet option offers the possibility to use the toilet in a dual mode: toilet and
bidet. The special spray nozzle has been designed to connect separately the fresh water for
the toilet flush and the water for the bidet function mixed and controlled with an elegant
handle also provided.
On most configurations, the mixer and the handle are integrated in the ceramic toilet body,
while on the toilet design Privilege and Evolution they are installed remotely wall mounted.
(see technical sheets to verify the type of integration possible for each model - integrated or
wall mounted)
Connect hot and cold water from the fresh water system to the mixer.
Use the handle to adjust the flow and the temperature of the water.
Whereas integrated in the ceramic the mixer/handle is always positioned on the right-hand
side. Whereas wall mounted (Privilege/Evolution) the default length of the hose is 60cm,
while this can be elongated by the shipyard according to the specific needs
Mixer and handle technical specifications:
Hot water connection
Cold water connection
Mixed water to toilet nozzle
Mixer body diameter
Flange
Handle
Hardware
Tecma S.r.l.
Via Flaminia | Loc. Castello delle Formiche
05030 Otricoli (TR)
ITALY
toilet motor
Inlet pump
Tank sensor
Power supply (with fuse on the red wire)
3/8"
3/8"
3/8"
O.D. 42mm
O.D. 60mm
Standard
Gaskets + mounting screws
Design and Flexi Line | instructions for installation and use | ENG
67
T +39 0744 709071
F +39 0744 719833
info@tecma.eu
www.thetfordmarine.com