Solenoid Valve - Thetford Marine TECMA Design Line Installation Et Mode D'emploi

3.3

Solenoid valve

Before installing the solenoid valve, clean the pipes (brazing or welding residues, metal chips,
seal material). A filter inside the solenoid valve prevents failures resulting from water
impurities. We recommend cleaning the solenoid valve filter regularly. After service, screw
both fitting back with the respective gaskets to the solenoid valve and tighten with a torque
of 2 N/m. Do not force the solenoid valve when tightening it. Do not obstruct the pilot hole
at the valve outlet. The entire piping section must be free from bottlenecks. Comply with the
recommended pressure range (refer to section A.2).
The solenoid can be regularly installed on the fresh water supply line, or - alternatively -
integrated in the WC through an optional hose connection that connects directly the water
inlet tube as shown in the following sequence.
Tecma S.r.l.
Via Flaminia | Loc. Castello delle Formiche
05030 Otricoli (TR)
ITALY
Design and Flexi Line | instructions for installation and use | ENG
59
* Installation of optional
adapter for installation
integrated solenoid in the
bowl.
T +39 0744 709071
F +39 0744 719833
info@tecma.eu
www.thetfordmarine.com