Installation Site - Thetford Marine TECMA Design Line Installation Et Mode D'emploi

▪
Only use stainless steel hardware. Always use the supplied ceramic-protection
rubber inserts. Any toilet assembly errors may result in improper movements,
which may damage objects or injure persons.
▪
The toilet is designed to dispose of human waste and toilet paper. Never flush
other materials types (e.g. paper towel, wet wipes, condoms, sanitary pads, dental
floss, etc.)
▪
Always use the screw caps, ceramic-protection rubber inserts, and connectors
supplied with the toilet.
▪
If in doubt, please refer to your TECMA distributor.
WARNING: Flush toilet paper only.
3.1

Installation site

Tecma toilets are designed for installation against the wall. This is to ensure the toilet
stability, optimize space and bathroom design. For hygiene purposes, it is recommended to
use sealant around the toilet base.
Before starting installation:
▪
make sure that the blackwater tank is in a suitable position and can be reached
from the toilet installation site
▪
make sure that the toilet configuration corresponds to the hydraulic and electric
system of the boat.
▪
make sure that the chosen model is suitable for the installation into, taking into
consideration:
 the foot overall dimensions
 correct seat cover opening
▪
there is sufficient space to fit all the pipes without damaging or bending them
inappropriately.
▪
the floor plate can withstand the weight of the toilet and of a potential user, even
during sailing, when these loads may be greater due to the pitching and rolling of
the boat.
▪
If recommended, there is any space to install a separate ventilated siphon
sufficiently above the toilet. This installation is recommended in the cases
Tecma S.r.l.
Via Flaminia | Loc. Castello delle Formiche
05030 Otricoli (TR)
ITALY
Design and Flexi Line | instructions for installation and use | ENG
56
T +39 0744 709071
F +39 0744 719833
info@tecma.eu
www.thetfordmarine.com