Operating The System; All-In-One Control Panel; One Button; Two Buttons - Thetford Marine TECMA Design Line Installation Et Mode D'emploi

2. OPERATING THE SYSTEM

2.1

All-in-one control panel

One button

Press the "FLUSH" button to start the automatic flush cycle, after which the toilet will be
refilled with a small amount of water, ready for the next use.

Two buttons

Press the "BEFORE USE" button before using the toilet. This will fill the toilet with a small
amount of water. Press the "AFTER USE" button after using the toilet. This will start the
automatic flush cycle, which will empty the toilet.
BEFORE USE
NOTE: The All-in-one control panel allows you to adjust the amount of water used
during the flushing cycle. A regulator placed at the back of the panel increases the
amount of water if turned clockwise or decreases it if turned anticlockwise. The
recommended water level is 1 cm above the ceramic outlet.
Tecma S.r.l.
Via Flaminia | Loc. Castello delle Formiche
05030 Otricoli (TR)
ITALY
Design and Flexi Line | instructions for installation and use | ENG
44
FLUSH
TANK LEVEL
AFTER USE
TANK LEVEL
T +39 0744 709071
F +39 0744 719833
info@tecma.eu
www.thetfordmarine.com