Multiframe Control Panel; Function - Thetford Marine TECMA Design Line Installation Et Mode D'emploi

2.2

Multiframe control panel

Function

Press the "BEFORE USE" button before using the toilet. This will fill the toilet with a small
amount of water. Press the "AFTER USE" button after using the toilet. This will start the
automatic flush cycle, which will empty the toilet.
BEFORE USE
NOTE: It is also possible to adjust the amount of water used during every flushing
cycle directly from the Multiframe wall switch. A specific regulator placed on its rear
increases the amount of water if turned clockwise or decreases it if turned
anticlockwise. The recommended water level is 1 cm above the ceramic outlet.
WARNING: The tank level LED is only an indicator. Do not use the system if the LED
is red.
Tecma S.r.l.
Via Flaminia | Loc. Castello delle Formiche
05030 Otricoli (TR)
ITALY
Design and Flexi Line | instructions for installation and use | ENG
45
AFTER USE
TANK LEVEL
T +39 0744 709071
F +39 0744 719833
info@tecma.eu
www.thetfordmarine.com