Changing flushing mode
The system is set on sailing mode by default. To switch from one mode to another:
1) Press and hold the BEFORE USE and AFTER USE buttons simultaneously
2) After 3 seconds, the sensor LED will flash: keep pressing.
3) After 5 seconds, the perimeter LED will flash: release the buttons.
4) The toilet will automatically do:
a. If you are setting from Sailing mode to Mooring mode: water inlet.
b. If you are setting from Mooring mode to Sailing mode: pump activation.
5) Repeat the procedure to change mode again.
Fig.1: from Sailing to Mooring
1. Press and hold the BEFORE USE
SAILING MODE
and AFTER USE buttons
simultaneously
2. After 3 seconds, the sensor LED
will flash.
Hold down.
3. After 5 seconds, the backlight
LED will flash.
Release the buttons.
4. The toilet will automatically inlet
water
MOORING
MODE
Tecma S.r.l.
Via Flaminia | Loc. Castello delle Formiche
05030 Otricoli (TR)
ITALY
Design and Flexi Line | instructions for installation and use | ENG
48
T +39 0744 709071
F +39 0744 719833
info@tecma.eu
www.thetfordmarine.com