Finger Guard - Miele professional PRI318 Mode D'emploi

Finger guard

The finger guard is a safety feature that must be checked daily for proper functioning be-
fore the machine is used.
 Risk of injury due to lack of finger guard function.
A malfunctioning finger guard function can lead to serious injury.
Shut down the flatwork ironer immediately.
Contact the Miele Customer Service Department without delay.
Ensure that the flatwork ironer is not put into operation by other persons and draw atten-
tion to the potential hazard.
After being switched on, the ironer will only switch to normal operating mode if the finger
guard has been activated properly after switching on the ironer. Otherwise, the ironer will
switch off again after a short amount of time.
"Finger guard" display symbol
If the display symbol  is flashing, gently press the underside of the finger guard once.
If fingertips become trapped between the roller and the finger guard, the ironer will be
stopped immediately and the heater plate disengaged. At the same time, the  symbol will
light up continuously. Press the  button to switch the ironer back on.
While the ironer is operating, do not use the finger guard intentionally to interrupt the
ironing process.
Press the  button to interrupt the ironing process.
en - Guide to the machine
33