Picking Laundry Out Of The Ironer; Pausing The Ironing Process; Eco Mode; Standby Mode - Miele professional PRI318 Mode D'emploi

Picking laundry out of the ironer

 Risk of burning due to hot edges of the heater plate outfeed.
While the ironer is in use, the heater plate becomes very hot. Ironed laundry may also be
very hot when it emerges from the heater plate.
Always take care when removing ironed laundry from the appliance.
Do not touch the edges of the heater plate outfeed.
The picker springs on the laundry picker band separate the ironed laundry from the roller.
The laundry can then be removed from the ironer.
 Risk of fire due to laundry self-ignition.
Hot laundry could self-ignite and cause a fire.
Allow the ironed laundry to cool down before packing or stacking it.
If a picker spring is loosened from its position, the ironer must be switched off. The picker
spring then needs to be moved by hand to the original position of the laundry picker band.
 Danger of squashing fingers in the laundry picker band.
When moving the laundry picker band, there is a risk of body parts being caught.
Before moving the laundry picker band, make sure that the area between the laundry
picker band and the side column is clear.
Always take care when moving the laundry picker band.

Pausing the ironing process

Press the  button to interrupt the ironing process and switch the appliance to pause

mode.
In pause mode, the roller stops and the heater plate disengages. The heater of the ironer
will initially remain switched on. During pause mode, the ironer remains ready for use.
Press the  button to start ironing again.


ECO mode

After an adjustable period of non-use (factory default setting = 10 minutes), the temperat-
ure is reduced to a value between 50 and 70 °C (factory default setting = 60 °C). The val-
ues can be set at the service level by the Miele Customer Service Department.

Standby mode

After an adjustable period of non-use, the ironer can switch to standby mode. In standby
mode, the roller is at a standstill and the heater plate is disengaged. During this process,
the ironer heater is switched off as well.
Press the  button to switch the ironer back on.
Standby mode is deactivated by default. Standby mode can be activated at service level
by the Miele Customer Service Department. The time at which the ironer will switch to
standby mode can be adjusted to a value between 1 and 30 minutes of non-use.

"FlexControl" foot switch

The roller can be stopped temporarily using the adjustable foot switch. This makes it easy
to avoid mistakes when feeding in items.
en - Using the ironer
39