Cleaning And Maintenance - Steba CR32 Mode D'emploi

∙ Never immerse the appliance in water.
∙ Do not operate the appliance if it is damaged, e.g. it fell down,
or it is damaged in any other way.
∙ Repairs at the appliance, e,g, exchange of a damaged power
cord, must only be done by authorized service persons, to avoid
any dangers.
∙ The appliance becomes hot. Do not move the appliance until it
cooled down
∙ Attention! Housing get hot. Danger of burns! Do
not place the appliance on a sensitive surface (e.g. pain-
ted furniture) and keep a distance of at least 70cm to
burnable materials.

Cleaning and maintenance

∙ Clean after every usage.
∙ Unplug the device.
∙ Never immerse into water.
∙ Leave the device to cool. Cleaning is easiest when the device is
lukewarm.
∙ Clean with a damp cloth.
Operation
∙ Unwind the cable
∙ Only use the appliance according the instructions on the rating label. The red lamp
shines
∙ Set the thermostat to the desired temperature. The green lamp shines, the device
heats.
∙ At the initial heating, the device can smoke slightly. After a few minutes the smoke
clears away.
∙ If the desired temperature is reached, the green light goes out. According to the
recipe, add small quantities of dough on the device.
∙ During the cooking time, the green light will turn off and on again. The thermostat
works.
∙ If the crepe is ready, remove it only with a wooden or plastic spatula so that the
coating will not get damaged.
∙ When the green light goes out, you can enter the next small quantity of dough
onto the device.
∙ The appliance is not suitable for roasting meat.
8