Service And Repair - Steba VK 4 Mode D'emploi

Troubleshooting
Problem Solution
Device does not ∙ Do you have power?
work ∙ Is the lid locked on the right and left?
∙ Is the film placed in the oval vacuum chamber?
∙ Is the aspiration covered by a film?
Air in the films ∙ The weld is not closed
∙ Did you use an inappropriate film? (use only films suitable for
∙ Is the film soiled or wet in the area of the weld?
∙ Is a crease at the weld?
∙ Is the sealing bar clean?
Disposal:
Packaging disposal:
Do not throw away the package materials. Please put it in the recycling bin.
Correct Disposal of this product
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the retailer
where the product was purchased. They can take this product for environmental safe
recycling.

Service and Repair:

If the appliance must be repaired, plaese get in touch with your trader or with the
manufacturer:
Distribution-Tel.: 09543 / 449-17 / -18, Service-Tel.: 09543 / 449-44, Fax: 09543 / 449-19
e-Mail: elektro@steba.com Internet: http://www.steba.com
14
vacuuming)
Gift box: Paper, should be put to the old paper collection point.
Plastic packaging material and foils should be collected in the
special collection containers.
STEBA Elektrogeräte GmbH & Co KG
Pointstr. 2, 96129 Strullendorf / Germany