Adding Salt To The Pool - Procopi Label Bleu ESS Notice D'installation Et Conseils D'utilisation

V.

ADDING SALT TO THE POOL:

Before adding salt to the pool, check that the each
of the water equilibrium parameters are within
range:
• pH, ideally between 7.2 and 7.4 with EES
• Calcium hardness
concentration of dissolved calcium), between 100
IMPORTANT:
• if the pool was treated with PHMB in the past,
eliminate all of this disinfectant before starting the
electrolyser.
Only use pool grade salt as stipulated in the
standard EN 16-401. No other types of salt
should be used.
If the pool has not just been entirely reilled,
measure the salt concentration with a suitable
USE THE FOLLOWING TABLE:
10
20
30
40
50
60
70
80
90
100
110
120
130
140
150
EXAMPLE:
A pool containing 100 m3 of water with an initial salt
concentration of 1000 ppm (1g/litre) -> add 300 kg
of salt to obtain a inal salt concentration of 3.5 g/
litre.
The quantity of salt calculated should be added as
follows:
• Spread the salt evenly over the entire surface of
the pool: the salt pellets settle on the loor of the
(water hardness
Initial salt concentration (ppm) in the pool
0 500 1000
Quantity (in kg) of salt to be added to the pool
40 35 30
80 70 60
120 105 90
160 140 120
200 175 150
240 210 180
280 245 210
320 280 240
360 315 270
400 350 300
440 385 330
480 420 360
520 455 390
560 490 420
600 525 450
and 250 ppm
• T.A. (total alkalinity), between 100 and 250 ppm
Use these parameters to ensure that the water is
correctly balanced (Taylor balance or Langelier
index – see appendix 1)
=
device because it may contain a little salt if the water
was treated with Chlorine before the electrolyser
was installed.
Calculate the weight of salt to be dissolved to
achieve a concentration of 3.5 g/litre (3500 ppm)
in the pool water. This will depend on the volume
of water in the pool (do not forget the buffer tank if
the pool has an overlow feature), and the initial salt
concentration measured beforehand.
1500 2000 2500
25 20 15
50 40 30
75 60 45
100 80 60
125 100 75
150 120 90
175 140 105
200 160 120
225 180 135
250 200 150
275 220 165
300 240 180
325 260 195
350 280 210
375 300 225
pool;
Start the iltration pump and let it run continuously
•
until the salt is totally dissolved (approximately 8
hours);
IMPORTANT! Do not turn the electrolyser on while
the salt is dissolving.
2015/02 - Indice de révision : B - Code : 29650
3000 3500 4500
10 5 0
20 10 0
30 15 0
40 20 0
50 25 0
60 30 0
70 35 0
80 40 0
90 45 0
100 50 0
110 55 0
120 60 0
130 65 0
140 70 0
150 75 0
41/84