Installing The Electrical/ Control Panel - Procopi Label Bleu ESS Notice D'installation Et Conseils D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

PH PROBE:
Unscrew the white cap and withdraw the probe
from its vial of liquid. Remove the black o-ring and
the white cap from the probe and replace them on
the vial (keep
this to winterize
the probe).
Unscrew
the
black nut from
the
tee,
be
careful
not
to
lose
the
r e m o v a b l e
parts.
Thread the black ring, the metallic washer and the
compression ring onto the body of the probe.
Make sure that the o-ring is correctly positioned on
the tee union.

INSTALLING THE ELECTRICAL/ CONTROL PANEL

Reminder:
The control panel is IP56 rated (according to the
standard EN 60529). It will not be damaged by
splashing, however it should be located at least 3.5
metres from the pool.
If this is not possible, it may be positioned closer to
the pool, but under no circumstances closer than 2
metres, subject to the condition that its power cable
is directly connected to a 30mA residual current
device (as stipulated in the standard NF C 15-100).
Mount the panel on a lat, solid, vertical wall in
the plant room using the 2 mounting brackets.
For added safety, position the panel at a height
38/84
2015/02 - Indice de révision : B - Code : 29650
i
i
i
i
t
fi i
2 ixing points
Radiator
Push the end of the probe into the union until the
end of the probe is located in the centre of the pipe
through which the water is lowing.
as indicated in the diagram on page 11.
IMPORTANT!
always be immersed, see the section on hydraulic
connections.
i
inaccessible to children.
i
IMPORTANT !
- To allow the panel to cool properly, do not obstruct
i
the low of air behind the panel.
- Do not install the panel is a closet or any other
place where inadequate ventilation could cause the
device to overheat and catch ire.
i
Screw
irmly onto the
union,
check that the
probe
be removed by
pulling gently.
Next, connect the
two probes to the
electrical
The active tips of the probes must
i
il i
the
nut
and
cannot
panel

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Label bleu ess pro

Table des Matières