Warning And Error Messages; Electrical Problems With The Cell - Procopi Label Bleu ESS Notice D'installation Et Conseils D'utilisation

•
PERIODIC INJECTION:
Make sure that iltration is running
•
• press the button to enter pH REDUCING –
AUTO mode.
•
PUNCTUAL INJECTION:
Make sure that iltration is running
•
• press the button three times to enter pH
REDUCING – MANUAL mode
Using the arrow keys ▼ and ▲, select an injection
•
volume LVL,
LVL = 1 -> volume = 70 cm3
IX.

WARNING AND ERROR MESSAGES:

•
SALT CONCENTRATION TOO LOW OR TOO HIGH
When the salt concentration is
within acceptable limits , the salt
gauge will rise to a point within
the ticked ( ) zone.
Salt concentration too low:
Low salt, the gauge is below the ticked range.
The word 'Low' and a salt shaker appear:
Fixed if the salt concentration is between 2
•
and 3 g/litre
• Blinking if the salt concentration is bewteen
1 and 2 g/litre
Below a salt concentration of 1 g/litre, the cell
will stop producing Chlorine and the message
NO CELL is displayed at the bottom of the LCD
screen LCD.
IMPORTANT :
A low salt warning could be triggered by excessive
build up of scale on the electrodes rather than a
real lack of salt. In the event of a low salt warning,
check that the electrodes are clean and check the
salt concentration with a suitable tester in case of
•

ELECTRICAL PROBLEMS WITH THE CELL

2 types of electrical problems are signalled if
detected:
• Short circuit in the cell power supply circuit: the
message SHRT CELL is displayed at the bottom
46/84
2015/02 - Indice de révision : B - Code : 29650
LVL = 2 -> volume = 2 x 70 = 140 cm3...
A few seconds after the volume is set, the pump
will begin to inject the selected volume. To cancel
injection, either before or during, stop the iltration
pump.
doubt.
A fault temperature sensor could also cause a
low salt warning
Salt concentration too high:
High salt, the gauge is above the ticked
range. in addition:
• between 5.5 and 6.5 g/litre, the message
"High" is displayed.
• between 6.5 and 8.0 g/litre, the icon
displayed.
• Above 8.0 g/litre, both the message and
the icon blink.
At a salt concentration above 10.0 g/litre, the cell
stops producing Chlorine and the icon is displayed
to the right of the LCD screen. The high salt icons
blink continuously and the message HIGH SALT
or SHRT CELL is displayed at the bottom of the
screen.
The salt concentration is lowered by renewing
a volume of pool water.
If the salt concentration is higher than 6.5
g/l, a volume of the pool water must be
renewed immediately in order to bring the salt
concentration down to an acceptable level.
of the screen.
► Cut power to the control panel
► Inspect the cable linking the panel to the cell very
carefully, starting at the terminal in the connection
is