Hydraulic Connections - Procopi Label Bleu ESS Notice D'installation Et Conseils D'utilisation

IV. INSTALLATION:
•

HYDRAULIC CONNECTIONS

IMPORTANT: when selecting the installation
sites of the various components, and before
creating the by-pass loops on the installation,
make sure that the power cables of each of
the components are long enough to reach the
electrical panel from the selected installation
site.
In the plant room,
create a by-pass
loop, downstream
from all other
devices mounted
on the hydraulic
circuit, to allow
installation of
the cell, the low
detector and the
pH-Clear pump
(if one is being
installed).
The cell may be oriented vertically or horizontally,
provided that the direction of low indicated in
•
SAMPLE CONFIGURATIONS
From other
is les
is les
Depuis les
components
autres organes
on the circuit
(pump, ilter,
du circuit fil
fil
ffage...)
(pompe, filtre
etc;)
ffage...)
chauffage...)
fi i
fi i
fi i
To the
ers le
Vers le
pool
retour
return
bassin
the diagram is respected.
To avoid the accumulation of air in the cell in the
event that air enters the hydraulic circuit, the cell
should not be installed at a high point on the
hydraulic circuit.
will require installation of a check valve.
The low detector should be positioned such
that the acid used to descale the cell will not
touch it. A check valve can ensure this.
i
Cell
Cellule
pH-Clear pump
Pompe pH-clear
Check valve (not supplied)
Clapet ani-retour (non fourni)
Flow detector + T°C probe
Détecteur débit + sonde T°C
Vanne ¼ de tour
1/4 turn valve
ers le
our
in
i
Optimal,
Opimal,
Opi
check
clapet non
clap
valve not
nécessaire
né
necessary
2015/02 - Indice de révision : B - Code : 29650
If installing a pH-
Clear pump, this
should be located
downstream
after the cell.
The by-pass should
be designed such
that acid injected
to descale the cell
(when iltration
stops) remains in
the cell. In some
conigurations, this
i
OK
35/84
just