Procopi Label Bleu ESS Notice D'installation Et Conseils D'utilisation page 34

Flow detector and
temperature sensor
pH-clear pump
Sensor mounting
Tee
pH probe
Redox probe
63-50 reduction
i ttings
Ballasted acid
suction strainer
Buffer solutions
pH = 4 et pH = 7
to calibrate the pH
probe
34/84
2015/02 - Indice de révision : B - Code : 29650
1
The pH-clear pump is used to inject acid into the
hydraulic circuit. It is glued to a length of tube,
diameter 63 mm, and comes with a transparent
shield to protect against splashing. It should be
mounted on the white barrel union of the cell,
and on another barrel union (not provided) at the
other end so that it may be dismounted.
The pH-Clear pump comes with:
1
• A spare injection tip
• 3 spare assemblies (black
compression tubing + blue suction
tips)
• 1 shiny black suction tube
1
1
1
*
1
The l ow detector is premounted on a Tee,
diameter 63 mm. The temperature probe is
positionned on the Tee at the base of the l ow
detector. Both are connected to a terminal in
the control panel.
Tee, diameter 63 mm, with two 63/50 reduction
i ttings
2 for the l ow detector tee, 2 for the probe
tees, 2 for the cell barrel unions, or for the
assembly (cell + pH clear)
To be mounted on the end of the suction
tube delivered with the pH-clear pump
X X
OPTION X
X
X
X
4* 6*
OPTION X
X