Starting - Efco SA 9010 Manuel D'utilisation Et D'entretien

the screw with the lever in the open
position.
5. Secure the corrugated cable sleeve
GB
connected to the handle, by means of the
retainers on the two clips.
6. To pull out the extension tube (D) from
inside the blower tube (B), twist the collar (E)
in the
the tube (C) can then be drawn out. Once
the extension is at the desired length, twist
the collar (E) back toward the
closed" position to lock the two tubes
together.
7. Fit the reducer (F) to the end of the
telescopic tube so that the curved nozzles
(G) can be used.
8. Couple the telescopic tube (C) to the reducer
(F) and attach one of the two curved nozzles
(G) by means of the bayonet fitting.
Adjusting the control handle
Correct positioning of the control handle is
e x t re m e l y i m p o r t a nt i n o rd e r to wo r k
comfortably with the blower. To adjust the
control handle position:
1. Raise the locking lever (1, Fig.5).
2. Find the most comfortable working position
by sliding the control handle and adjusting
its angle.
3. When you find the preferred position, lock the
control handle by lowering the locking lever.
Adjusting the harness and quick release
WARNING - The harness must be adjusted
with the engine stopped.
Before using the blower it is extremely important
to ensure the weight of the machine is correctly
balanced on your shoulders. This is done by
adjusting the length of the shoulder straps until
the machine is perfectly in contact with your back
and shoulders.
Note that correct balancing of the machine is
especially important when working on gradients.
To tighten the shoulder straps pull as shown in
Fig.7.
22
"padlock open" direction, and
To loosen the shoulder straps lift the buckle with
the movement shown in Fig.8.
In the presence of danger, release the machine
from your shoulders by proceeding as follows:
1. Use one hand to press the quick release tabs
on the right-hand shoulder strap (shown in
the box in Fig.6) as shown in Fig.9.
2. Accompany the machine by bending your
upper body slightly to the left: the blower will
"padlock slide off your shoulders.

5. STARTING

FUELING
WARNING: Gasoline is an extremely
flammable fuel. Use extreme caution when
handling gasoline or fuel mix. Do not smoke
or bring any fire or flame near the fuel or the
unit.
· To reduce the risk of fire and burn injury,
handle fuel with care. It is highly flammable.
· Mix and store fuel in a container approved for
gasoline.
· Mix fuel outdoors where there are no sparks or
flames.
· Select bare ground, stop engine, and allow to
cool before refueling.
· Loosen fuel cap slowly to release pressure and
to keep fuel from escaping around the cap.
· Tighten fuel cap securely after refueling. Unit
vibration can cause an improperly tightened
fuel cap to loosen or come off and spill
quantities of fuel.
· Wipe spilled fuel from the unit. Move 3 metre
away from refueling site before starting engine.
· Never attempt to burn off spilled fuel under
any circumstances.
· Do not smoke while handling fuel or while
operating the unit.
· Store fuel in a cool, dry, well ventilated place.
· Never place the machine in a combustible area