Operating Instructions - Stihl SR 430 Notice D'emploi

Stopping the Engine
Move the setting lever in the
N
direction of 0 – the engine stops –
the setting lever springs back to the
on position.
Other Hints on Starting
Engine stalls in cold start position c or
under acceleration
Move the choke knob to o and
N
continue cranking until the engine
runs.
Engine does not start in warm start
position o
Move the choke knob to c and
N
continue cranking until the engine
runs.
If the engine does not start
Check that all settings are correct.
N
Check that there is fuel in the tank
N
and refuel if necessary.
Check that the spark plug boot is
N
properly connected.
Repeat the starting procedure.
N
SR 430, SR 450
Fuel tank run until completely dry
After refueling, press the manual
N
fuel pump bulb at least five times –
even if the bulb is filled with fuel.
Set the choke knob according to
N
engine temperature.
Now start the engine.
N

Operating Instructions

During Operation
After a long period of full throttle
operation, allow the engine to run for a
short while at idle speed so that engine
heat can be dissipated by the flow of
cooling air. This helps protect engine-
mounted components (ignition,
carburetor) from thermal overload.
After Finishing Work
Storing for a short period: Wait for the
engine to cool down. Keep the machine
in a dry place, well away from sources of
ignition, until you need it again. For
longer out-of-service periods – see
"Storing the Machine".
English
17