Stihl SR 430 Notice D'emploi page 7

Use
Work only in the open or in very well
–
ventilated locations, e.g. open
greenhouses
Do not eat, drink or smoke while
–
working with plant protection
chemicals
Never blow through nozzles or other
–
components by mouth
Avoid contact with plant control
–
chemicals – immediately change
clothing contaminated with plant
control chemical
Do not spray in windy conditions
–
Unfavorable weather conditions may
result in an incorrect concentration of the
plant protection product. Overdosing
may damage plants and the
environment. Under-dosing may result
in unsuccessful plant treatment.
In order to reduce the risk of damage to
the environment and plants, do not
operate the sprayer:
in windy conditions
–
at temperatures above 25°C in the
–
shade
in direct sunlight
–
In order to reduce the risk of accidents
and damage to the power tool, never
operate the power tool with:
flammable liquids
–
viscous or sticky liquids
–
caustic or corrosive chemicals
–
liquids hotter than 50 °C
–
SR 430, SR 450
Bearing
During work breaks, do not leave
–
the power tool in the hot sun or near
any heat source
Do not store spray solution in the
–
container for longer than one day
Store and transport plant protection
–
products only in approved
containers
Never store the plant protection
–
products in containers intended for
foods, drinks or animal feed
Do not store plant protection
–
products with foods, drinks or
animal feed
Keep plant protection products out
–
of the reach of children and animals
Store the power tool empty and
–
clean
Store plant protection products and
–
power tool in a place secured
against unauthorized use
Store plant protection products and
–
power tool in a dry place protected
from frost
Disposal
Never dispose of residual plant
protection products or contaminated
rinsing solutions in waterways, drains,
sewers, street gutters or manholes.
Dispose of residual chemicals and
–
used containers in accordance with
local waste disposal regulations
Transporting the machine
Always stop the engine.
Transporting in a vehicle:
Secure the machine against
–
overturning, damage and fuel
spillage
The container must be empty and
–
clean
Refueling
Gasoline is an extremely
flammable fuel. Keep
clear of naked flames. Do
not spill any fuel – do not
smoke.
Always shut off the engine before
refueling.
Do not fuel a hot engine – fuel may spill
and cause a fire.
Always remove the power tool from your
back and put it on the ground before
refueling. Fuel the unit only when it is
standing securely on the ground.
Open the fuel cap carefully to allow any
pressure build-up in the tank to release
slowly and avoid fuel spillage.
Only refuel the machine in a well
ventilated place. If fuel has been spilled,
immediately clean the machine – do not
allow your clothes to be splashed with
fuel. If that happens, change your
clothes at once.
Check for fuel leakage!
Never start the engine if
fuel has been spilled or is
leaking – Fatal burns may
result!
English
5