Technical Details; Preliminary Checks - DITEC SPRINT Manuel D'installation

1.

TECHNICAL DETAILS

GB
Power supply
Absorption
Maximum torque
Opening time
Closing time
Intermittence
Accessories power supply
Operation type
Temperature
Degree of protection
Control panel
Applications
m = door wing width
kg = door wing weight
Recommended
dimensions
Limit dimensions
2. REFERENCE TO ILLUSTRATION
The given operating and performance features can only be gua-
ranteed with the use of DITEC accessories and safety devices.
2.1 Standard installation references (fig. 1)
[1] Gearmotor
[2] Radar
[3] Connect to the power supply by means of the appropriate
plug. Connection to the grid is made with independent
channels and separated from the connections to the
command and safety devices.
[4] Mechanical opening stop
2.2 Automation references (fig. 2)
[5] Control panel
[6] ON/OFF switch
[7] Casing
[8] Arm support
[9] Base plate
3. INSTALLATION
Unless otherwise specified, all measurements are expressed
in millimetres (mm).

3.1 Preliminary checks

Check the stability, the weight of the door wing and the regu-
larity of the movement, without friction (if necessary reinforce
the frame). Any "door closes" must be eliminated or completely
cancelled.
Attention: check the correct working in the case of installation on
doors that separate environments with different pressures.
SPRINT - IP1546
SPRINT
230 V~ / 50-60 Hz
0,2 A
25 Nm
min 7 s / 90°
max 3 s / 90°
S2 = 30 min
S3 = 80%
24 V= / 0,15 A
Motor opening
Motor closing
-20 °C / +55 °C
[batteries: +10 °C / +50 °C]
IP12D
165
3.2 Installation with articulated arm
Use the articulated arm for doors that open outwards (seen from
automation side).
-
12
SPRINTJ
120 V~ / 60 Hz
min 7 s / 90°
max 3 s / 90°
S2 = 30 min
S3 = 80%
24 V= / 0,15 A
Motor opening
Motor closing
-20 °C / +55 °C
[batteries: +10 °C / +50 °C]
Remove the casing and fasten the automation on the wall,
respecting the measurements indicated in the figure: refer
to the hinge axis.
0,4 A
25 Nm
IP12D
165