Horizon Hobby Hangar 9 Ki-43 Oscar 60cc Manuel D'utilisation page 13

6. Secure the servo ball link to the servo arm using an M3 x 10 button
head screw, M3 washer and M3 lock nut. Use a 2.5mm hex wrench
and 5.5mm nut driver to tighten the hardware.
7. Secure a 6-inch (150mm) servo extension to the servo using a
commercially available retainer (SPMA3054).
 The length of the extension may vary depending on servo selection.
The extension listed works with the recommended servos.
8. Tie or tape the string located inside the wing to the end of the servo
lead.
9. Use the string to pull the servo lead through the wing and out at the
root.
 We left a small amount of the string on the aileron
servo lead so it can be quickly differentiated between
the flap servo lead that will be installed later.
10. Install the aileron servo in the wing with the output facing the
leading edge. Make sure to prepare the servo mounting holes by
threading a servo mounting screw into each hole and removing
them. Harden the mounting screw locations with thin CA before
installing the servo.
Ki-43 Oscar 60cc ARF
11. Secure the servo ball link to the control horn using an M3 x 10
button head screw, M3 washer and M3 lock nut. Use a 2.5mm hex
wrench and 5.5mm nut driver to tighten the hardware.
 Connect the servo to the radio system to hold the aileron servo in
the centered position. Disconnect the ball from the control horn
and adjust the linkage so the aileron is in the neutral position.
Reinstall the hardware once the linkage has been adjusted.
12. Use the steps outlined for the retract cover to install the aileron
cover.
13 EN