Horizon Hobby Hangar 9 Ki-43 Oscar 60cc Manuel D'utilisation page 23

6. Use crimping pliers to secure the sleeve to the cable.
 Use caution to not apply excessive pressure and cut
the sleeve instead of securing it to the wire.
7. Repeat the process to secure the remaining cable to the tail wheel
arm.
8. Slide an M3 lock washer, then an M3 washer on an M3 x 15 socket
head cap screw. Prepare all four screws.
9. Place a drop of threadlock on each of the screws. Secure the tail
wheel bracket in the fuselage using the screws from the previous
step and a 2.5mm hex wrench.
10. Slide the cables into the tubes in the fuselage. Retrieve the cables
inside the fuselage.
Ki-43 Oscar 60cc ARF
11. Slide a sleeve on one end of the cable. Pass the cable through the
hole in the cable fi tting. Pass the cable back through the sleeve. With
the rudder servo and tail wheel centered, apply light tension on the
cable. Use crimping pliers to secure the sleeve to the cable.
 The servo arm can be removed from the servo if
necessary. Use caution to not press too hard and cut
the crimp instead of securing it to the wire.
 Repeat the process to secure both cables.
 The cables may stretch slightly over time. Periodically check
the cables to make sure there is still light tension on them.
Use side cutters to trim any excess cable to prevent it from interfering
with the operation of the model.
12. Secure the rudder servo arm using the screw provided with the
rudder.
13. Place the tail wheel cover back on the fuselage.
14. Use hobby scissors to cut a slot in the fairing so it can be placed
over the tail wheel assembly.
23 EN