Mattresses - arjo Enterprise 9000X Notice D'utilisation

Mattresses

WARNING
Always use a mattress of the correct size and type. Incompatible mattresses can
create hazards.
Entrapment hazards may exist when using a very soft mattress, even if it is the correct
size.
The maximum recommended mattress thickness for use with split side rails is 18cm.
Read the instructions for use supplied with the mattress.
Where the maximum patient weight specified for the mattress is different to that
specified for the bed, the lower value applies.
A label on the calf extension sheet indicates the correct mattress size:
12.5 - 18cm
NOTE
The numbers 1, 2 and 3 on the label indicate different mattress platform lengths; refer to "Bed
length adjustment" on page 23.
Mattresses and When choosing bed and mattress combinations, it is important to consider
split side rails the use of split side rails based on clinical assessment of each individual
patient and in line with local policy.
When assessing the suitability of a mattress for use with split side rails, the
following factors should be considered:
• The bed is designed to provide an acceptable split side rail height
when used with a foam mattress up to 18cm thick.
• Specialist powered air / foam replacement mattresses will typically
envelop the patient when loaded and can generally be deeper than a
foam mattress without compromising safety. Other makes of specialist
mattress replacement must be assessed individually prior to use to
verify sufficient clearance is maintained.
• Mattress overlays are not recommended for use with this bed.
• To ensure compliance with IEC 60601-2-52, an approved Arjo
mattress should be used. Compliance with this standard when using
other mattresses must be validated by the user.
• For more information on suitable mattresses and mattress
replacements, contact your local Arjo office or approved distributor.
A list of Arjo offices can be found at the back of this manual.
1 - 191cm
2 - 202cm
3 - 214cm
88cm
Mattress size label
15