Setting The Shielding Gas Volume - Abicor Binzel MB EVO PRO Mode D'emploi

4 Putting into operation
NOTICE
• Check the minimum fill level on the cooling unit.
• Make sure that the coolant supply and return have been installed properly. Coolant
supply = blue, Coolant return = red.
• Do not use any deionized or demineralized water as coolant or for tightness or flow tests.
This may impair the service life of your welding torch.
• We recommend the use of ABICOR BINZEL series BTC coolant for liquid-cooled
welding torches.
 Consult the applicable safety data sheet.
• Please consult the applicable safety data sheet.The cooling system must be purged of any
air each time the device is commissioned and after every cable assembly change:
disconnect the coolant return hose from the coolant recirculator and hold it over a
collection receptacle. Close the opening on the coolant return hose. Then re-open it by
abruptly releasing it. Repeat until the coolant flows into the collection receptacle
continuously and without air bubbles.

4.3 Setting the shielding gas volume

NOTICE
• The type and amount of shielding gas used depend on the welding task and the gas
nozzle geometry.
• Make all shielding gas connections gas-tight.
• To prevent the shielding gas supply from becoming clogged by impurities, the cylinder
valve must be opened briefly before connecting the cylinder. This will expel any impurities
that may be present.
EN - 12
MB EVO PRO/MB EVO
BAL.0414.0 • 2019-05-17