Putting Into Operation - Abicor Binzel MB EVO PRO Mode D'emploi

MB EVO PRO/MB EVO

4 Putting into operation

DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of maintenance,
servicing, disassembly and repair work:
• Switch off the power source.
• Close the gas supply.
• Close off the coolant supply.
• Close off the compressed air supply.
• Disconnect all electrical connections.
DANGER
Risk of injury and machine damage when handled by unauthorised persons
Improper repair work and modifications to the product may lead to serious injuries and
damage to the device. The product warranty will be rendered invalid if the device is handled
by unauthorised persons.
• Operating, maintenance, cleaning and repair work may only be carried out by qualified
personnel (in Germany see TRBS 1203).
NOTICE
• Please take note of the following instructions:
 3 Product description on page EN-5
The MIG/MAG manual welding torch is equipped upon delivery. For information about
replacing wear parts, refer to the following chapter:
 8.2 Cleaning the cable assembly on page EN-16
BAL.0414.0 • 2019-05-17
4 Putting into operation
EN - 7