Protecting The Pressure Washer With Antifreeze; Transporting; Transporting The Pressure Washer; Storing - Stihl RE 90 Notice D'emploi

13 Transporting

12.2 Protecting the pressure washer with antifreeze

If the pressure washer cannot be protected from frost during
transport or storage, the pressure washer should be
protected by a glycol-based antifreeze. The antifreeze
prevents water inside the pressure washer from freezing and
causing damage to the pressure washer.
► Remove spray lance
► Connect the shortest possible water hose to the pressure
washer.
The shorter the water hose, the less antifreeze is needed.
► Mix the antifreeze as described in the antifreeze
Instruction Manual.
► Pour antifreeze into a clean container.
► Insert water hose into container of antifreeze.
► Squeeze and hold spray gun trigger.
► Switch on pressure washer.
► Hold down spray gun trigger until an even jet of antifreeze
is delivered from the spray gun and point the spray gun
into the container.
► Press and release spray gun trigger several times.
► Switch off pressure washer and unplug mains plug from
the socket.
► Detach spray gun, high-pressure hose and water hose
and allow antifreeze to run into the container.
► Store and dispose of antifreeze in accordance with the
applicable regulations and in an environmentally
responsible manner.
13 Transporting

13.1 Transporting the pressure washer

► Switch off the pressure washer and pull the mains plug out
of the socket.
► Empty the detergent container or secure it so that it cannot
topple over, fall down and cannot move.
0458-814-9621-A
1
► If pulling the pressure washer: Pull pressure washer using
handle (1).
► If carrying the pressure washer: Carry the pressure
washer by the handle (1) and the carrying handle (2).
► If transporting the pressure washer in a vehicle, ensure
that the following conditions are fulfilled:
– The pressure washer is standing upright or is lying on its
back.
– The pressure washer is secured using lashing straps,
cargo ties or a net, and cannot topple over and move.
– If the pressure washer cannot be transported in a frost-
proof environment: Protect pressure washer using
antifreeze.

14 Storing

14.1 Storing the pressure washer

► Switch off pressure washer and unplug mains plug from
the socket.
► The pressure washer should be stored in such a way that
the following conditions are fulfilled:
– The pressure washer is out of the reach of children.
– The pressure washer is clean and dry.
– The pressure washer is in an enclosed room.
– The pressure washer is in a temperature range above
0 °C.
English
2
1
61