Switching Off The Additional Device - Harvia SENTIO JUST-105W-CO Instructions D'installation Et Mode D'emploi

Instructions for use for the user
When the dimmer switch function is activated
When the dimmer switch function for the additional output is activated, the power
for the additional device can be set to any level between level 1 to level 7.
1. Press the additional device symbol 8.
► The additional device LED 9 lights up.
► The set power level is displayed for one second in the power level display 3.
2. Press (press and hold) the additional device symbol 8 and hold it down for
several seconds.
► While pressing and holding the symbol, the power level is increased by an
increment of one every second. Once power level 7 has been reached,
it starts again at power level 1.
3. Once the preferred power level has been reached, let go of the button.
► The additional device will operate at the power level selected.
► After a number of seconds, the power level display 3 goes out.
When the dimmer switch function is deactivated
When the dimmer switch function for the additional output has been deactivated,
you can only switch the additional device on and off. The device will always
operate at full power.
● Press the additional device symbol 8.
► The additional device LED 9 lights up.
► The additional device switches on.

10.9. Switching off the additional device

● Press the additional device symbol 8.
► The additional device switches off.
► The additional device LED 9 goes out.
p. 37/46
EN