Important Information For Your Safety; Intended Use; Safety Information For The Installer - Harvia Sentiotec S2-18 Instructions De Montage Et Mode D'emploi

Instructions for installation

2. Important information for your safety

The S2-18, S2-18S and S2-30 power boosters are produced in accordance with
the applicable safety regulations for technical units. However, hazards may occur
during use. You should therefore adhere to the following safety information and
the specific warnings in the individual chapters.

2.1. Intended use

The S2-18, S2-18S and S2-30 power boosters are used to expand the maximum
switching load of your sauna control unit. The device can be used for all sauna
control units which have a 230 V switch output for the safety and switching circuit.
Any use exceeding this scope is considered improper. Improper use can result
in damage to the product, severe injuries or death.

2.2. Safety information for the installer

● Installation may only be performed by a qualified electrician or similarly quali-
fied person.
● Installation and connection of the power booster may only be performed when
the power supply is disconnected.
● Observe all regulations applicable in the installation location.
● For your own safety, consult your supplier in the event of problems that are
not explained in sufficient detail in the installation instructions.
● A three-phase shut-off device with a 3 mm contact opening must be provided
during installation. This is provided by the fuse.
p. 4/12