Switching Off Combi Operation; Switching On The Additional Output - Harvia SENTIO JUST-105W-CO Instructions D'installation Et Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 94
Instructions for use for the user
► In two-sensor mode with a humidity-temperature sensor, the humidity
LED wheel c then shows the actual temperature in blue. In two-sensor
mode with a bench sensor and in single-sensor mode, it continues show-
ing the preset humidity.
The evaporator (humidity function B) can only be started when the sauna
heater (temperature function A) is switched on. The maximum humid-
ity level which can be set depends on the temperature of the sauna.
The higher the sauna temperature, the lower the maximum humidity
level which can be set.
If you are using the evaporator in normal, timed operation (without a hu-
midity-temperature sensor) and the current cabin temperature is less than
30 °C, then the evaporator is activated continually for 10 minutes. This
ensures that the water in the evaporator reaches a basic temperature
level. Once the 10 minutes have elapsed, operation using time humidity
control continues.

10.7. Switching off combi operation

● Press the temperature symbol d in the middle of the temperature touch
wheel e.
► The sauna heater and the evaporator are switched off.
► The temperature LED wheel f goes out.

10.8. Switching on the additional output

Infrared lamps, or infrared heat plates, for example, can be connected to the
additional output on the sauna control unit.
WARNING!
Risk of fire
Flammable objects that are placed on or in front of the infrared lamp
could ignite and cause fires.
● NEVER place flammable objects on or in front of the infrared lamp.
● Make sure that NO flammable objects have been placed on or in
front of the infrared lamp before you switch it on.
p. 36/46

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

J sentio ust-105d-co1-015-6331-015-338

Table des Matières