Activating/Deactivating Phase Alignment; Setting The Light Operating Mode; Activating/Deactivating The Foil Sensor - Harvia SENTIO JUST-105W-CO Instructions D'installation Et Mode D'emploi

Installation instructions, only for experts
● The function selection switch 2 is set to the ON position as standard. This ac-
tivates two-sensor mode.
● If you wish to deactivate single-sensor mode, place the function selection
switch 2 in the OFF position.

8.3. Activating/deactivating phase alignment

Phase alignment is activated or deactivated using the function selection switch 3.
● The function selection switch 3 is set to the ON position as standard. This ac-
tivates phase alignment.
● If you wish to deactivate phase alignment, place the function selection switch 3
in the OFF position.

8.4. Setting the light operating mode

The light for the sauna room can either be dimmed or switched on and off.
The dimmer switch function is activated or deactivated using the function selec-
tion switch 5.
● The function selection switch 5 is set to the ON position as standard. This ac-
tivates the dimmer function.
● If you wish to deactivate the dimmer function for the sauna room light, place
the function selection switch 5 in the OFF position.

8.5. Activating/deactivating the foil sensor

If an infrared heat plate is connected to an additional output, a foil sensor must
be used. The foil sensor must be activated with the aid of the function selection
switch 6.
● The function selection switch 6 is set to the OFF position as standard. This ac-
tivates the foil sensor.
● If you wish to activate the foil sensor, place the function selection switch 6 in
the ON position.
p. 28/46