Assembling The Cabin; Assembling The Base Frame; Assembling The Cabin Walls; Assembling The Roof Elements - Harvia Mini S1212SV Manuel

Instructions for installation
3.

Assembling the cabin

ATTENTION!
Note the floor plans on Page 10 and Page 11 as well as the illustra-
tions starting on page 15 (after the last language).

3.1. Assembling the base frame

Start with the base frame and screw it to the corners. Move the base frame to
the final position of the sauna.

3.2. Assembling the cabin walls

Note the outside/inside of the wall elements.
Make sure the ventilation element is correctly positioned.
It must be placed diagonally opposite the heater.
Start assembling the wall elements with the ventilation element and screw it to
the corner post (G, H). The other wall elements are connected by tongue and
groove and are fixed by mounting the roof frame. Check the right angles (see
tip on page 4).
Mount the multiclips to the front sides of the wall panels and to the corner
posts (A, B). Make sure that the multiclips are correctly aligned - the corner
posts are connected to the wall elements from top to bottom.
Fit the ventilation slider.

3.3. Assembling the roof elements

Insert the roof elements and screw them to the cabin walls. Note the cable outlet.

3.4. Assembling the benches

Mount the bench support slats on the side wall elements. Connect the angle
bench to the sauna bench using M10 x 120 screws. Screw the adjustable feet
into the bench foot. Fix the bench foot to the angled bench by tightening up the
lock and screw the bench foot to the side wall.
Assemble the bench screen and the backrest.
p. 12/14