Washing Instructions - medi Lumbamed disc Mode D'emploi

English
• (Fig. 5) Now, slide your right hand into
the outer hand strap on the righthand
fastener side.
• (Fig. 6 + 7) Pull both fastener sides
together in the middle, so that they
can be velcroed over each other as far
at the same distance. When fastening,
ensure that the back brace is in the
middle. The orthotic is on properly
when the lower fastener edge is just
above the pubic bone (see Fig. 9).
• (Fig. 8 ) Now unfasten the velcro ends
of the pull straps and pull these
forward at the same time. You can
adjust the tightness to suit your own
requirements and manage your pain
levels.
• Information for technicians: (Fig. 10)
The strap length may be adjusted by
cutting it at the edge of the Y fastener.
Please take care that trained staff
instruct you when putting on the
support for the first time.
Removing / Changing the stabilising
rods
Hold the lower end of the rod and pull it
slightly downwards with the knitted
fabric. At the same time, slightly pull
apart the upper opening in the knitted
fabric. You can now remove the rod
easily from the pocket. For inserting the
rods, slide them into the individual
pockets again and reposition them in
the same way.

Washing instructions

Before washing, please remove the
internal rods (cf. Fig. 12) as well as the
strap supporting system by detaching it
from the Y connecting piece (cf. Fig. 11).
During replacement make sure that the
medi logo on the back stays is at the top.
Velcro tabs must be closed for washing.
Fabric softener, fats, oils and ointments
can attack the material and the Clima
Comfort Effect can be impaired. Soap
residues can cause skin irritation and
material damage. You can wash the
product by hand, preferably using a
medi clean detergent, or in delicate cycle
at 30°C using a mild detergent without
fabric conditioners.
• Do not bleach.
• Leave to dry naturally.
• Do not iron.
• Do not dry clean.

   
Note on storage
Must be stored dry and at room
temperature. Must be protected from
the sun and moisture.
Composition of the material
Polyamide, Polyester, elastan, ABS
Plastic
Statutory Defects Liability /
Contractual Guarantee
Consistent with legal guidelines.
Disposal
The product can be disposed of in the
domestic waste.
Your medi Team
Wishes you a rapid recovery!