Checking/Replacing Battery - Num'axes PET at SCHOOL Soft Guide D'utilisation

Diagram. 5

Checking/replacing battery

●
When the battery is too weak, a beep sound indicates it in two cases:
When switching On the collar: a series of close beep sounds + number of beep
−
sounds to indicate the operating mode,
When switching Off the collar: a series of close beep sounds.
−
Think of replacing the battery.
When the battery is too weak, the product works under safety mode, which means that it is
out of use.
Due to greater use during your dog's training, your first battery may not last as long as the
replacement batteries.
Replace the old battery with a new one as follows:
− Remove the 2 screws from the battery cover using a screwdriver.
− Remove the battery cover.
− Remove the battery by using the magnet (magnetic key).
Insert the new battery, paying attention to the polarity indicated under the
−
battery holder (See § Fitting the battery).
Gb - 18
MINIMUM MAXIMUM
sensitivity sensitivity
MEDIUM
sensitivity
Small plastic
Screwdriver