Checking/Replacing Battery Of Remote Control - Num'axes CANICOM 200 Guide D'utilisation

It's up to you to use the beeper depending on the way you want to train your dog. With the beeper button
you can:
- send a sound to your dog when it is disobedient,
- draw its attention,...
It's very important to always use the beeper button in the same way in order not to disturb
your dog.
F button: Flash stimulation
Press the «F» button to send a warning to your dog using stimulations transmitted by the two contact
points located on the receiver collar for a defined length of time of less than one second.
A « transmission » symbol will appear on the LCD screen of the remote control; the indicator light on the
collar goes from flashing green to permanent red while the stimulations are being sent.
C button: Continuous stimulation
Press the «C» button to send a warning to your dog using stimulations transmitted by the two contact
points located on the receiver collar, this will last for as long as the button is pressed but limited to
8 seconds maximum.
If you press the «C» button for more than 8 seconds, the collar will automatically go into safety mode for
a few seconds before restarting itself normally.
Nota: Beeps can be associated to the stimulation by pressing first the «C» button and then the
« + » and « - » : stimulation level control buttons
Use the "+"/"-" buttons for rapid adjustment of the stimulation level of the receiver collar.
9 levels are available.
Level 1: very weak stimulation. Level 9: strong stimulation.
Always start with the lowest level of stimulation.

Checking/replacing battery of remote control

Performance (radio range) of the remote control may deteriorate as batteries become weak. Be
prepared to replace the battery.
To check the condition of the battery, turn on the remote control and look at the battery level indicator
on the LCD screen.
Gb - 25
button.