Num'axes PET at SCHOOL Soft Guide D'utilisation page 19

Changing the sensor
●
Two different sensors are supplied. The length of the sensor must be sufficient to have proper
contact with the dog's skin, enabling the device to operate correctly.
stic
If you have a long haired dog and the short sensor fitted to the collar in the factory is
ver
inadequate, remove the short sensor and replace it with the long one supplied with the kit.
When changing the sensor, do not press on the threaded rod, it could damage the
components underneath.
A moderate manual screwing is sufficient (do not use any key).
If you screw the sensor too much, bark detection is likely to be unefficient.
● Fitting the collar
The strap should be adjusted so that the sensor comes right into contact with the dog's skin in
order to ensure good barking detection.
If the strap is too loose, the collar will not operate properly. Moreover, it might move
−
around the dog's neck and repeated rubbing of the sensor on the skin can cause
irritation.
− If the strap is too tight, the dog will have breathing difficulties.
Do not leave the collar more than 8 hours a day around your dog's neck and take the
time to check that there are no signs of irritation when your dog is not wearing it.
If this happens, remove the collar until all signs of skin irritation have disappeared
Checking the device operates correctly
●
Switch on the collar (turn the collar on mode 3, thus you will be able to check the
−
operation of ultrasounds and vibrations).
Slowly rub the sensor on a slightly rough surface (change the detection sensitivity
−
if necessary).
The collar will emit ultrasounds and/or vibrations (according to the chosen
−
configuration).
Important : after being activated 5 times in quick succession, the collar will
automatically go into safety mode for 15 seconds, before restarting itself normally.
Gb - 19