Num'axes PET at SCHOOL Soft Guide D'utilisation page 17

Changing modes
●
In factory, the collar's mode is positioned on mode 3 (ultrasounds + vibrations).
To change the collar's mode, when switching on the collar you need to approach and keep the
magnetic key in contact with the red mark.
A series of beep sounds is emitted (from 1 to 3) indicating the selected mode.
Keep the magnetic key in contact with the red mark to run through modes.
Remove the magnetic key when you have reached the mode you wish.
The collar will memorize your selected mode.
Next time you will switch on the collar , your collar will be turned on to the last mode you previously selected.
The chart below indicates how your collar operates according to the modes you have selected:
Number of beep sounds heard
when switching modes
● Setting the barking detection sensitivity
Setting the barking detection sensitivity is a very important preliminary operation. In fact, this
setting determines the correct operation of the product.
It ensures detection of any barking but helps avoid unnecessary detection.
The detection must therefore be sufficiently sensitive but not overly sensitive.
In factory, detection sensitivity is set on the maximum position (maximum sensitivity).
To adapt the detection sensitivity to the barking strength of your dog, you should proceed as follows:
− Remove the 2 screws from the battery cover with a screwdriver.
Remove the battery cover.
−
Carefully turn the setting screw according to the sensitivity you wish (See Diagram. 5)
−
CAUTION: the adjustment system has a stop for the minimum sensitivity
and a stop for the maximum sensitivity. Turn delicately and without forcing
with the supplied screwdriver.
Put the battery cover back in place taking care to insert first the little pin at the
−
bottom of the battery cover (See diagram. 3).
Retighten moderately the 2 screws.
−
Gb - 17
1
2
3
Mode Operation
1 ultrasounds only
2 vibrations only
3 ultrasounds + vibrations