Checking/Replacing Battery Of Remote Control - Num'axes CANICOM 300+ Guide D'utilisation

4.4. C button: continuous stimulations
Press the C button to send a warning to your dog using continuous stimulations delivered by the two contact points
of the collar for as long as the button is pressed (but for 8 seconds maximum).
If you press the C button for more than 8 seconds, the collar will automatically go into safety mode for a few seconds
before working normally again.
4.5. B button: programmable booster for emergency situations
Press the B button to stop your dog instantaneously. You can choose the stimulation level you think to be the best for
an immediate effect. As a result, you do not need to press the
Those stimulations are transmitted by the two contact points located on the collar for as long as the button is pressed
(but for 8 seconds maximum).
If you press the B button for more than 8 seconds, the collar will automatically go into safety mode for a few seconds
before working normally again.
Configuration procedure of the Booster button for the A or B collar
The stimulation level selected thanks to the Booster key can be different for each collar.
- Activate the remote control by pressing for 1 second the On/Off red button
- Press the A or B button for approximately 5 seconds until the stimulation level flashes on the LCD screen.
- Press the
or
- Press the A or B button to confirm the stimulation level selected.
4.6. and buttons: stimulation level control buttons
Use the and buttons for rapid adjustment of the stimulation level of the receiver collar.
15 levels are available: Level 1: very weak stimulations / Level 15: strong stimulations
Always start with the lowest level of stimulation and define the level from which your dog reacts by increasing
gradually if necessary.
4.7. Retro-lightning of the LCD screen
You can light the LCD screen for approximately 6 seconds by pressing briefly the ON/OFF red button
½ second).

5. Checking/replacing battery of remote control

Performance (especially radio range) of the remote control may deteriorate as battery becomes weak. Be prepared to
replace the battery.
To check the condition of the battery, turn on the remote control and look at the battery level indicator on the LCD
screen. The symbols which appear indicate the following:
Battery fully charged.
Weak battery: prepare to replace the battery (3-V CR2 lithium battery).
Dead battery: your product switches to safety mode and the system locks up. The battery must be replaced.
NUM'AXES advises to use the same type and same brand of batteries as those supplied when purchasing the
product. Other brands of batteries may not operate, or may not be completely compatible with your product.
You can purchase the suitable batteries on www.numaxes.com or from your supplier.
Guide CANICOM 300+ - indice A – Mars 2020
button to modify the stimulation level.
button repeatedly.
.
(approximately
17/52