Checking/Replacing Battery; Changing The Sensor - Num'axes iki voice Guide D'utilisation

Listening/recording of vocal messages

Checking/Replacing battery

When the battery is too weak for the operation of the product, sound beeps indicate it in 2 cases:
- When switching On the collar: a series of close sound beeps + number of beeps meant to
indicate the operating mode are emitted
- When switching Off the collar: a series of close sound beeps are emitted
Prepare to replace the battery.
When the battery is too weak, the product works under safety mode, which means that it is out of use.
You need to replace the battery by a new battery of the same type (3 volts CR 2450 lithium battery).
Do as follows:
- Remove the 2 screws from the battery cover using the supplied screwdriver.
- Remove the battery cover.
- Remove the dry battery by using the supplied magnet (magnetic key).
- Insert the new battery paying attention to the polarity indicated under the battery holder (See
Diagram 2)
- A sound beep is emitted indicating that the battery was properly inserted.
- If you do not hear any sound beep after inserting the battery, immediately remove it from the
battery holder by using your magnet. Check the polarity before inserting the battery once again.
If you still do not hear any sound beep, check the operation by switching the collar On and Off.
- Replace the battery cover taking care to insert first the little pin at the bottom of the battery
cover (See diagram 3).
- Retighten moderately the 2 screws.

Changing the sensor

Two different length sensors are included in the package. The size should be long enough to have
proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long haired dog and the short sensor fitted to the collar in the factory is inadequate,
remove the short sensor and replace it with the long one supplied with the kit.
MINIMUM sensitivity
Diagram 5
Gb - 18
MAXIMUM sensitivity
MEDIUM sensitivity