Epson V12H949001 Instructions D'installation page 9

Installation Instructions
1. Determine location of studs behind drywall. (See Figure 6)
NOTE:
For wood or steel stud walls, mark at least two locations
for attachment a minimum of 16" apart and a maximum
of 24" apart (steel only), AND within slots on wall
bracket assembly.
NOTE:
For concrete walls, mark at least two locations for
attachment a minimum of 16" apart, AND within slots
on wall bracket assembly.
Fasteners
4
(2 or 3)
Figure 6
2. Measure and mark the appropriate distance below the
projector mount wall bracket (U) according to the
measurements listed in Table 2 and referencing the
Installation Template. (See Table 2)
3. Drill one pilot hole (see Table 1 for size) at each location
marked in Step 2 (See Figure 6) and follow fastener
information (appropriate for wall type) located in Table 1.
NOTE:
Reference Fastener Installation Methods in
Appendix section at end of Installation Instructions.
4. Fasten screen mounting bracket (T) to wall using fasteners
appropriate to wall type (See Table 1). (See Figure 6)
Installing Adapter Plate to Projector
NOTE:
Different quantities of fasteners are used for lamp
projectors and laser projectors.
1. Attach adapter plate (P) to projector using the correct
number of fasteners for the type of projector. (See Figure 7)
• Lamp Projector: Use four M4 x 10mm Phillips flat
head screws (E1); OR
• Laser Projector: Use five M4 x 10mm Phillips flat
head screws (E1).
3
2
(T)
(Laser projector shown
as example)
(P)
Attaching Projector Mount Assembly
NOTE:
The projector mount assembly (V) ships with the boom
arm pre-set to the correct depth. However, depth
adjustment may be necessary dependent upon wall's
vertical plane.
1. Lift projector mount assembly (V) up to projector mount wall
bracket (U) and hook top edge onto cross plate of wall
bracket. (See Figure 8)
(V)
V12H949001 / AN3WA100
(E1) x 4 (lamp projector)
1
OR
(E1) x 5 (laser projector)
This screw and
mounting hole
used ONLY for
laser projectors
Figure 7
1
Figure 8
(U)
9