Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V12H949001 / AN3WA100
2.
Slide lower edge onto cross plate of wall bracket. (See
Figure 9)
(V)
Figure 9
3.
Loosely install two 1/4-20 x 5/8" hex head bolts (D) through
holes on projector mount assembly boom arm (V) and into
sliding nuts on projector mount wall bracket (U). (See
Figure 10)
(V)
(V)
3
(U)
(U)
4
Figure 10
NOTE:
The left side of the projector mount assembly boom arm
should be located 1.48 inches to the left of the screen
center (when facing projector mount). (See
Dimensions drawing and Installation Template.)
4.
Tighten hex head bolts in projector mount wall bracket.
10
(U)
2
(D) x 2
Installing Projector
1.
Make sure latch on projector mount assembly (V) is in
UNLOCKED position and remove key (taped on side) from
projector mount.(See Figure 11)
2.
Lift projector with attached interface (P) and slide buttons on
interface into slots on projector mount assembly (V). (See
Figure 11)
3.
Slide latch to LOCKED position to lock projector in place.
(See Figure 11)
4.
OPTIONAL: Lock with key.
Latch
2
4
Slot
3
Locked
Unlocked
1
Buttons
(P)
Figure 11
Installation Instructions
(V)
2
Publicité
Table des Matières
