Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
17. When the marker positions have been checked, remove the
markers and press the
The following screen is displayed. (See Figure 47)
Figure 47
18. Swipe through the dots with your finger as shown. When the
angle adjustment has been done correctly the dots will
disappear. (See Figure 48)
NOTE:
Finger touch operations may not function correctly if
you are wearing bandages, artificial nails, nail polish, or
anything else that may obstruct your fingers.
Figure 48
19. When all the dots around the outside edge of the projected
image have disappeared, press the
remote control.
Installing Control Pad
1.
Fasten two control pad plates (N) to back of control pad
(included with projector) using four 8-32 x 3/8" Phillips head
screws (G1). (See Figure 49)
button on the remote control.
button on the
1
G1 x 4
Figure 49
2.
Place control pad bracket (X) against wall and screen and
mark location of wall fastener. (See Figure 50)
3.
Remove control pad bracket (X) from wall and drill pilot hole
at marked location.
4.
Insert anchor (F3) into pilot hole using a hammer. (See
Figure 50)
5.
Place control pad bracket (X) against wall, matching up pilot
hole and anchor with mounting hole in bracket.
6.
Fasten side of control pad bracket (X) against screen using
two #8 x 1/2" Phillips head screws (F1). (See Figure 50)
7.
Fasten bracket to wall using on #8 x 1-1/2" Phillips head
screw (F2). (See Figure 50)
Screen
6
(F1) x 2
(F2)
7
Figure 50
V12H949001 / AN3WA100
(N)
(X)
2
4
5
Wall
3
(F3)
21
Publicité
Table des Matières
